Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across University City
If the cap on your University City chimney is missing, bent, or the wrong size, or if the crown has cracked and started shedding mortar, we handle the whole job: multi-flue caps, crown repair, crown coating, and new caps sized to the flue. Cap and crown work here means understanding attached rowhouses and twin homes, where one brick stack often serves two homes. Call (888) 841-6695. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. The estimate is free, and the local pro who does the work is licensed and insured as their state requires.
Why University City Homeowners Call Chimney Sweep Mayfair for Chimney Cap & Crown
We are a chimney specialist, not a generalist who sweeps as an add-on, and that matters on University City’s tight brick rows. Our technicians have up to 9 years of experience, and they regularly work multi-flue stacks on attached properties where one cap has to serve two owners. We treat cap and crown work as a full-system job: the crown, the cap, the flue liner, and the smoke chamber are all checked while the cap is off, so you’re not scheduling a second contractor for the next thing that turns up.
We specify Gelco and Famco caps because a cap has to fit the flue it actually sits on, not the flue listed on the box. A cap that’s too small or sits too low lets wind-driven rain and debris in; one that’s too tall or undersized for the stack can change draft. Our local knowledge comes from the building type: we know what these 1910s and earlier stacks look like by the time a crown has failed, and we scope the work accordingly.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in University City
Multi-Flue Cap Installation
A multi-flue cap covers every flue opening in a shared stack in one housing, instead of stacked individual caps that don’t line up. On University City row and twin homes, that’s often two fireplace flues plus a furnace or water-heater flue in the same brick mass. We measure the openings and specify the right collars so each flue is capped correctly, not just covered.

Cap Replacement
Stock caps rust, bend, and loosen at the collar over time, and street trees in University City drop limbs onto rooflines every wind event. When we replace a cap, we inspect the flue tile edge, the crown top, and the smoke chamber below before anything new goes on. A replacement cap without that check is just new metal over the same old problem.

Crown Repair
The crown is the sloped concrete or mortar top that sheds water off the chimney and away from the brick. When it cracks or spalls, meltwater from winter freeze-thaw runs behind the masonry and down toward the flue liner. We repoint and rebuild crowns with proper mortar and an overhang so water clears the sides of the stack, which matters on exposed University City chimneys that take weather from every direction.

Crown Coating
A crown coating restores a crown that’s structurally sound but has lost its face: hairline cracking, surface spalling, a rough top that holds water. Coating is faster than a full rebuild and leaves the crown water-resistant across seasons. We apply it only when the underlying crown is solid; if the crown is failing through, we’ll show you that before quoting a coating.
Trusted Brands We Service in University City
We work with the product lines professional chimney contractors rely on: Gelco and Famco caps, HeatShield for firebox and smoke-chamber restoration, and Olympia Chimney supply. We don’t stock parts on a truck or keep a warehouse in your neighborhood. What that means for you is a straightforward process: we measure the flues, specify the cap or crown material that fits, and the local pro arrives with the right part for the job rather than the closest thing on hand. Turnaround on a cap job is usually a single visit once the sizing is confirmed.
Common Chimney Cap & Crown Problems We See in University City Homes
- Cracked, spalling crowns on exposed brick stacks. Repeated freeze-thaw winters open hairline cracks into spalled sections, and meltwater then tracks down a shared flue and weakens the clay-tile liner before the first cold snap. A crown that sheds water properly protects the flues inside it.
- Missing or undersized caps on rowhouse multi-flue stacks. The dense tree canopy over University City drops leaf litter onto caps and into open flues, and animal debris follows. On a connected stack, a blocked flue can affect the neighbour’s flue as much as yours.
- Poorly sealed cap and flashing junctions on party-wall stacks. Where two adjacent units meet the same stack, an improperly sealed junction lets wind backdraft down a furnace flue or pull exhaust toward an unused fireplace flue. This is the cross-contamination issue that cap and crown work is meant to close off.
- Chimneys that sat unused for years in student rentals. Many 1910s rowhouses in University City sat idle between tenants, and when the first fire gets lit, sweeps find birds’ nests, raccoon debris, and disconnected flue tiles in a chimney that “worked fine last time.” A cap is the first line of defence.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Cap & Crown in University City, PA
A typical cap installation on a University City rowhouse runs $250 to $650, with a single-flue stock cap at the low end and a custom multi-flue cap at the high end. Crown coating runs $300 to $600. Crown repair or a partial rebuild runs $550 to $1,400 depending on access, roof pitch, and how much spalling has to be cut back. A full crown rebuild on a shared stack is a bigger job and gets its own written estimate. On a 1910s twin home, the condition of the existing clay liner often sets the scope before the cap goes on, so the estimate reflects what the inspection actually shows, not a round number. The written estimate sets the final price, and nothing is recommended without camera evidence you can see for yourself.
How Cap and Crown Work Goes on University City’s Attached Rows
On University City’s attached brick rows, a crown that has cracked and spalled after repeated freeze-thaw winters lets meltwater run behind the masonry and down onto the flue liner. The original multi-flue cap is often missing, or bent flat by fallen limbs from the street trees. A qualified local sweep typically performs a Level 2 inspection, checks the flue liner and smoke chamber while the cap is off, then repoints the crown with a proper mortar overhang or applies a crown coating and sets a correctly sized multi-flue cap, so draft stays true and no neighbour’s appliance exhaust migrates across the shared party wall.
Many 19104 rowhouses and twins share a single brick stack between adjacent units. That changes how cap and crown work is scoped: a multi-flue cap often covers two flues serving two different owners, and a neighbour’s furnace or water-heater flue venting into the same stack can push exhaust toward a cap that isn’t tall enough or properly sealed. This is the shared-stack problem, and treating it as one cap job without understanding the venting behind it is how backdraft and odour complaints start. Where relevant, the local pro works with your insurer and documents everything with photos so both parties on a party-wall stack know what was found and what was done.
We Also Serve Cities Near University City
The same cap and crown work covers homes just outside this neighborhood: Point Breeze, Center City, Bala Cynwyd, and Frankford. We also work across the wider University City area, covering tower and crawlspace stacks on the same attached building type. If you’re near the edge of the neighborhood, call and we’ll confirm coverage before we book the estimate. Our full chimney cap & crown service details are on the service page.
Serving University City, PA – Our Local Coverage Area
We serve University City and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in University City
Yes. A multi-flue cap can cover both flues in a shared stack when the openings are measured correctly and each collar is sized to its flue. On University City rowhouses, the cap has to be specified for both flues, not just the one your fireplace uses, because a cap that’s too small or open at the wrong side lets wind backdraft down the neighbour’s furnace flue. We measure both openings and build to that. Call (888) 841-6695 for an exact quote – estimates are free.
Because freeze-thaw cycles are hard on an exposed crown, and a crown without a proper overhang lets water sit at the brick line and work its way in, then split the mortar when it freezes. University City’s mild winters are still cold enough for repeated freeze-thaw through the season, and a crown on a twin home often takes the worst of it on the exposed face. Crown repair rebuilds the slope and overhang; crown coating seals a crown that’s still structurally sound. Call (888) 841-6695 for an exact quote – estimates are free.
Check the cap first, then the flue: a chimney that sat unused often has birds’ nests, raccoon debris, and disconnected flue tiles that a visual look at the firebox won’t reveal. What usually happens in a University City student rental is that the cap was missing or bent, and the chimney filled with leaf litter from the tree canopy over the roofline. A Level 2 inspection with a camera answers this before you light anything. Call (888) 841-6695 for an exact quote – estimates are free.
Yes, and it’s the most common reason a shared-stack cap job gets redone. If the cap isn’t tall enough or properly sealed at the junction where the two units meet the same party-wall stack, furnace exhaust can migrate toward an unused fireplace flue or backdraft into the neighbour’s space. Correctly sized collars and a properly seated multi-flue cap are what stop this. Call (888) 841-6695 for an exact quote – estimates are free.
A chimney that isn’t burned every year still needs an annual visual check, and a full Level 2 inspection at the point a cap or crown is replaced or a rental comes back into service. The reason isn’t creosote buildup, it’s weather and intrusion: a cracked crown, a displaced cap, or debris from the tree canopy can damage the liner over a winter with no fire lit. If the crown is sound and the cap is sealed, work can safely wait until the next season. Call (888) 841-6695 for an exact quote – estimates are free.
If your cap is missing or bent, or a crown is spalling on your University City rowhouse or twin, call (888) 841-6695 for a free estimate. We answer 24/7 and dispatch from 7am to 7pm, Sunday through Friday, and we’ll show you what the camera sees before recommending anything.
Written by the team at Chimney Sweep Mayfair.